Data Sheet

11
RIGOL
Hardware Pass/Fail Test
Enhanced FFT Analysis
The MSO5000 series is equipped with hardware pass/fail
test function as the standard configuration, which can be
used in signal monitoring for a long time, signal monitoring
during design, and signal test in the production line. You can
set the test mask based on the known "standard" waveform,
and then compare the signal under test with the "standard"
waveform to display the statistics on the test results. When
a successful or failed test is detected by the oscilloscope,
you can choose to immediately stop monitoring, enable the
beeper to sound an alarm, or save the current screen image.
Also, you can choose to continue monitoring.
The MSO5000 series can analyze 1 Mpts of FFT, which
improves the frequency resolution to a large extent,
convenient for you to better analyze the disturbance noise in
the circuit under test. To adjust the spectrum waveforms to
be observed, set the center frequency and the span; or set
the start frequency and the stop frequency. The MSO5000
series also provides the peak search function, which can
auto mark up to 15 peaks and display their frequencies
and amplitudes in the form of a list. Such information and
the non-peak section in the frequency-domain cursor
measurement can greatly improve the working efficiency of
the engineers.
The Pass/Fail test function can quickly make statistics on the occurrence
probability of the signal exceptions.