User manual

Chapter 2 Command System RIGOL

MSO5000 Programming Guide 2-223

:WAVeform Commands

The :WAVeform commands are used to read waveform data and relevant settings. The :WAVeform:MODE

command is used to set the reading mode of waveform data. In different modes, the definitions for the

parameters are different, as shown in Figure 2-1 and 2-2.

Figure 2-1 Parameter Definitions in NORMAL Mode

Figure 2-2 Parameter Definitions in RAW Mode

Note

[1]

: In RAW mode, YINCrement and Verticalscale of the memory waveforms are related to the currently selected

Verticalscale.

XORigion

YORigion

YREFerence

YINCrement

[1]

XINCrement = 1/SampleRate

XORigion

YORigion

YREFerence

YINCrement = VerticalScale/25

XINCrement=TimeScale/100

XREFerence