User manual

RIGOL Chapter 2 Command System
2-146 MSO5000 Programming Guide
HighZ: (-2.5V + current
amplitude/2) to (2.5V -
current amplitude/2)
50Ω: (-1.25V + current
amplitude/2) to (1.25V -
current amplitude/2)
<phase>
Real
0° to 360°
0°
Remarks
 This series of commands are used to select the waveform shape.
NOISe: noise
PULSe: pulse
RAMP: ramp waveform
SINusoid: sine waveform
SQUare: square waveform
ARBitrary: arbitrary waveform
 <freq>: sets the frequency of the specified waveform (this parameter is not
available for Noise waveform). By default, the unit is Hz.
<amp>: sets the amplitude of the specified waveform. By default, the unit is
Vpp.
<offset>: sets the DC offset of the specified waveform. By default, the unit is
V
DC
.
<phase>: sets the start phase of the specified waveform (this parameter is not
available for Noise waveform). By default, the unit is degree (°).
 This series of commands allow users to omit one or multiple parameters. When
all the parameters are omitted, the commands only configure the specified
function/arbitrary waveform generator channel to the specified waveform,
without modifying the corresponding parameters.
 The four parameters <freq>, <amp>, <offset>, and <phase> should be
appeared in sequence. In the command, the parameters are configured in
sequence, and you are not allowed to set the latter parameter without setting
the former one. For example, you cannot set the parameter <amp> directly by
omitting the parameter <freq>.
[:SOURce[<n>]]:OUTPut[<n>][:STATe]
Syntax
[:SOURce[<n>]]:OUTPut[<n>][:STATe] <bool>
[:SOURce[<n>]]:OUTPut[<n>][:STATe]?
Description
Enables or disables the output of the specified function/arbitrary waveform generator
channel; or queries the output status of the specified function/arbitrary waveform
generator channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
{1|2}
When omitted, by default, the
operations are carried out on
GI.
<bool>
Bool
{{1|ON}|{0|OFF}}
0|OFF
Remarks
The [:SOURce[<n>]] and :OUTPut[<n>] are used to specify the channel of the
function/arbitrary waveform generator. The former has a high priority over the latter.
That is, when the former is omitted, the latter is used to specify the channel; when the
former is not omitted, the former is used to specify the channel.
Return
The query returns OFF or ON.