User manual

Chapter 2 Command System RIGOL
MSO5000 Programming Guide 2-145
[:SOURce[<n>]]:APPLy?
Syntax
[:SOURce[<n>]]:APPLy?
Description
Queries the current output configuration of the specified function/arbitrary waveform
generator channel.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
{1|2}
When omitted, by default,
the operations are carried
out on GI.
Return
Format
The query returns the current output configuration in "<waveform
name>,<frequency>,<amplitude>,<offset>,<start phase>" format. If no
corresponding parameter is found, DEF is replaced with the specified parameter value.
Example
:APPLy? /*The query returns SIN,1000.000000,2.000000,0.500000,90.000000.*/
[:SOURce[<n>]]:APPLy:NOISe
[:SOURce[<n>]]:APPLy:PULSe
[:SOURce[<n>]]:APPLy:RAMP
[:SOURce[<n>]]:APPLy:SINusoid
[:SOURce[<n>]]:APPLy:SQUare
[:SOURce[<n>]]:APPLy:USER
Syntax
[:SOURce[<n>]]:APPLy:NOISe [<amp>[,<offset>]]
[:SOURce[<n>]]:APPLy:PULSe [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:RAMP [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:SINusoid [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:SQUare [<freq>[,<amp>[,<offset>[,<phase>]]]]
[:SOURce[<n>]]:APPLy:USER [<freq>[,<amp>[,<offset>[,<phase>]]]]
Description
Configures the specified function/arbitrary waveform generator channel to output the
signal with the specified waveforms and parameters.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
{1|2}
When omitted, by default, the
operations are carried
out on GI.
<freq>
Real
Sine: 0.1 Hz to 25 MHz
Square: 0.1 Hz to 15 MHz
Pulse: 0.1 Hz to 1 MHz
Ramp: 0.1 Hz to 100 kHz
Arb: 0.1 Hz to 10 MHz
1 kHz
<amp>
Real
Related to the currently
set output impedance
HighZ: 20 mVpp to 5 Vpp
50Ω: 10 mVpp to 2.5 Vpp
5 Vpp
<offset>
Real
Related to the current
output impedance and
amplitude
0 V
DC