Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- MSO5000-E Series Overview
- Document Overview
- Quick Start
- General Inspection
- Appearance and Dimensions
- To Prepare for Use
- Front Panel Overview
- Rear Panel Overview
- Front Panel Function Overview
- User Interface
- Touch Screen Controls
- Parameter Setting Method
- To Use the Kensington Security Lock
- To Use the Built-in Help System
- To View the Option Information and the Option Installation
- To Set the Vertical System
- To Set the Horizontal System
- To Set the Sample System
- To Trigger the Oscilloscope
- Trigger Source
- Trigger LEVEL/Threshold Level
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Edge Trigger
- Pulse Trigger
- Slope Trigger
- Video Trigger
- Pattern Trigger
- Duration Trigger
- Timeout Trigger
- Runt Trigger
- Window Trigger
- Delay Trigger
- Setup/Hold Trigger
- Nth Edge Trigger
- RS232 Trigger (Option)
- I2C Trigger (Option)
- SPI Trigger (Option)
- CAN Trigger (Option)
- FlexRay Trigger (Option)
- LIN Trigger (Option)
- I2S Trigger (Option)
- MIL-STD-1553 Trigger (Option)
- Zone Trigger
- Trigger Output Connector
- Operations and Measurements
- Digital Voltmeter (DVM) and Frequency Counter
- Power Analysis (Option)
- Histogram Analysis
- Digital Channel
- Protocol Decoding
- Reference Waveform
- To Enable Ref Function
- To Select the Reference Channel
- To Select the Ref Source
- To Adjust the Ref Waveform Display
- To Save to Internal Memory
- To Clear the Display of the Reference Waveform
- To View Details of the Reference Waveform
- To Reset the Reference Waveform
- Color Setting
- Label Setting
- To Export to Internal or External Memory
- To Import from Internal or External Memory
- Pass/Fail Test
- Waveform Recording & Playing
- Search and Navigation Function
- Display Control
- Function/Arbitrary Waveform Generator (Option)
- Store and Load
- System Utility Function Setting
- Remote Control
- Troubleshooting
- Appendix
- Index
Chapter 18 Store and Load RIGOL
MSO5000-E User Guide 18-13
To Clear the Internal Memory Safely
1) Press Storage Disk, rotate the multifunction knob to select the internal
memory "Local Disk(C)".
2) Press SecurityClear, and then a prompt message for confirming security clear
is displayed.
3) Press OK to clear all the files stored in the internal memory.
Factory Settings
Press Default on the front panel, then a prompt message "Restore default?" is
displayed. Press OK or tap OK to restore the oscilloscope to the factory default
settings, as shown in the table below.
Table 18-1 Factory Settings
Parameter
Factory Settings
Horizontal
Vertical
Acquire
Trigger
Display
Function/AWG (Gen)
Cursor
Storage
Utility
Math
Logic Analyzer (LA)
Protocol Decoding (Decode)
Ref
Horizontal
Horizontal
Timebase
1 μs
Horizontal Position
0 s
Delayed Sweep
Off
Timebase Mode
YT
Fine
Off
Horizontal
Expansion
Center
Vertical
Vertical Scale
100 mV
Vertical Offset
0 V
CH1
On
CH2
Off