Instructions

Chapter 18 Store and Load RIGOL
MSO5000-E User Guide 18-9
1. Select English Input Method
If the current input method is "En/中/繁", please go to Step 2. If the current
input method is "中/繁/En" or "繁/En/中", rotate the multifunction knob
to
select the input switch key and press the knob
continuously to switch to
"En/中/繁". "En" is located first and highlighted.
2. Clear the Name Input Area
If there is no character in the "Name Input Area", please go to Step 3. If there
are characters in the "Name Input Area", press rotate the multifunction knob
to select the Delete key
to delete all the characters in the name input area
in order.
3. Input the First Character "F"
1) If the current setting is uppercase input, please go to Step 2). If the current
setting is lowercase input, rotate the multifunction knob
to select
"Caps" and press down the knob to switch to the uppercase input.
2) Rotate the multifunction knob to select "F" and press down the knob.
The character is displayed in the English selection area.
3) In the English selection area, rotate the multifunction knob
to select "F"
and press it down. Then, "F" is displayed in the name input area, "F" is input
successfully. If the character is not found in the current page, press
to
go to the next page until you find the desired character.
4. Input the Other Characters
Use the same method to input the remaining letters "ilename" by referring to
Step 3. Pay attention to the upper-lower case of the letters when inputting them.
5. Modify or Delete the Unwanted Characters that Have Been Entered.
While entering a filename, you can modify or delete the unwanted character if
necessary. To delete the input characters, rotate the multifunction knob
in
the virtual keypad to select the delete key
. Press down the key to delete the
characters. To modify the input characters, delete the unwanted characters and
input the desired characters again. If the character to be modified is in the
middle, press the delete key
to delete the characters starting from the last
one to the character to be modified, then input the new character again.
If the touch screen is enabled, tap to directly move the cursor to the character
required to be modified or deleted, and then input the desired character again
or delete the unwanted character.
Tip
If characters already exist in the letter input area, when you rotate the
multifunction knob
to delete the characters in the name input area, the
characters in the letter input area will be deleted first.