Instructions

Chapter 2 Command System RIGOL
MSO5000-E Programming Guide 2-11
:BUS<n>:EEXPort
Syntax
:BUS<n>:EEXPort
Description
Exports the decoding information in the specified decoding bus event table in CSV form.
Parameter
Name
Type
Range
Default
<n>
Discrete
{1|2|3|4}
——
Example :BUS1:EEXPort C:/123.csv /*Exports the decoding information in the bus event
table to the local Disk C, with the filename 123.csv.*/
:BUS<n>:POSition
Syntax :BUS<n>:POSition <pos>
:BUS<n>:POSition?
Description
Sets or queries the vertical position of the bus on the screen.
Parameter
Name
Type
Range
Default
<n>
Discrete
{1|2|3|4}
——
<pos> Integer -167 to +217
Related to the
channel offset
Return
Format
The query returns an integer ranging from -167 to +217.
Example
:BUS1:POSition 200 /*Sets the vertical position of the bus to 200.*/
:BUS1:POSition? /*The query returns 200.*/
:BUS<n>:THReshold
Syntax :BUS<n>:THReshold <value>,<type>
:BUS<n>:THReshold? <type>
Description
Sets or queries the threshold of the specified decoding source.
Parameter
Name
Type
Range
Default
<n>
Discrete
{1|2|3|4}
——
<value> Real
(-5×VerticalScale–OFFSet) to
(5×VerticalScale–OFFSet)
0
<type> Discrete
{PAL|TX|RX|SCL|SDA|CS|CLK|MISO|MO
SI|LIN|CAN|CANSub1}
——
Remarks  For VerticalScale, refer to the :CHANnel<n>:SCALe command. For OFFSet, refer to
the
:CHANnel<n>:OFFSet command.
 For RS232 decoding, only when the Rx source is enabled, can you set the threshold.
 For SPI decoding, only when the MOSI source is enabled, can you set the threshold.
Return
Format
The query returns the threshold of the specified decoding source in scientific notation.
Example :BUS1:THReshold 2.4,PAL /*Sets the threshold of the PAL decoding source to 2.4 V.*/
:BUS1:THReshold? PAL /*The query returns 2.400000E0.*/