Instructions

RIGOL Chapter 2 Command System
2-134 MSO5000 Programming Guide
[:SOURce[<n>]] Commands
The [:SOURce[<n>]] commands are used to set the relevant parameters of the built-in function/arbitrary
waveform generator. <n> can set to 1 or 2, which indicates the corresponding built-in function/arbitrary
waveform generator channel. When <n> or :SOURce[<n>] is omitted, by default, the operations are
carried out on AWG GI. The commands are only available for the model installed with the MSO5000-AWG
option.
Command List:
 [:SOURce[<n>]]:FREQuency[:FIXed]
 [:SOURce[<n>]]:PHASe[:ADJust]
 [:SOURce[<n>]]:PHASe:INITiate
 [:SOURce[<n>]]:FUNCtion[:SHAPe]
 [:SOURce[<n>]]:FUNCtion:RAMP:SYMMetry
 [:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
 [:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:OFFSet
 [:SOURce[<n>]]:PULSe:DCYCle
 [:SOURce[<n>]]:MOD:TYPE
 [:SOURce[<n>]]:MOD:AM[:DEPTh]
 [:SOURce[<n>]]:MOD:AM:INTernal:FREQuency
 [:SOURce[<n>]]:MOD:FM:INTernal:FREQuency
 [:SOURce[<n>]]:MOD:AM:INTernal:FUNCtion
 [:SOURce[<n>]]:MOD:FM:INTernal:FUNCtion
 [:SOURce[<n>]]:MOD:FM[:DEVIation]
 [:SOURce[<n>]]:SWEep:TYPE
 [:SOURce[<n>]]:SWEep:STIMe
 [:SOURce[<n>]]:SWEep:BTIMe
 [:SOURce[<n>]]:BURSt:TYPE
 [:SOURce[<n>]]:BURSt:CYCLes
 [:SOURce[<n>]]:BURSt:DELay
 [:SOURce[<n>]]:APPLy?
 [:SOURce[<n>]]:APPLy:NOISe
 [:SOURce[<n>]]:APPLy:PULSe
 [:SOURce[<n>]]:APPLy:RAMP
 [:SOURce[<n>]]:APPLy:SINusoid
 [:SOURce[<n>]]:APPLy:SQUare
 [:SOURce[<n>]]:APPLy:USER
 [:SOURce[<n>]]:OUTPut[<n>][:STATe]
 [:SOURce[<n>]]:OUTPut[<n>]:IMPedance