User Manual
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- MSO2000A/DS2000A Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 To Set the Vertical System
- Chapter 3 To Set the Horizontal System
- Chapter 4 To Set the Sample System
- Chapter 5 To Trigger the Oscilloscope
- Trigger Source
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Edge Trigger
- Pulse Trigger
- Runt Trigger
- Windows Trigger (Option)
- Nth Edge Trigger (Option)
- Slope Trigger
- Video Trigger (HDTV Option)
- Pattern Trigger
- Delay Trigger (Option)
- TimeOut Trigger (Option)
- Duration Trigger (Option)
- Setup/Hold Trigger
- RS232 Trigger
- I2C Trigger
- SPI Trigger
- USB Trigger (Option)
- CAN Trigger (Option)
- Trigger Output Connector
- Chapter 6 MATH and Measurements
- Chapter 7 Digital Channel
- Chapter 8 Protocol Decoding
- Chapter 9 Reference Waveform
- Chapter 10 Pass/Fail Test
- Chapter 11 Waveform Record
- Chapter 12 Display Control
- Chapter 13 Signal Source
- Chapter 14 Store and Recall
- Chapter 15 System Function Setting
- Chapter 16 Remote Control
- Chapter 17 Troubleshooting
- Chapter 18 Specifications
- Chapter 19 Appendix
- Index
Chapter 18 Specifications RIGOL
MSO2000A/DS2000A User’s Guide
18-11
Symmetry 0 to 100%
Noise Bandwidth 25 MHz (typical)
Built-in
Waveform
Frequency
Range
100 mHz to 1 MHz
Arbitrary
Waveform
Frequency
Range
100 mHz to 10 MHz
Waveform
Length
1 to 16 k points
Internal
Storage
Location
10
Frequency Accuracy 100 ppm (lower than 10 kHz)
50 ppm (higher than 10 kHz)
Resolution 100 mHz or 4 bits, the larger of the two
Amplitude Output Range 20 mVpp to 5 Vpp, HighZ
10 mVpp to 2.5 Vpp, 50 Ω
Resolution 100 μV or 3 bits, the larger of the two
Accuracy 2% (1 kHz)
DC Offset Range ±2.5 V, HighZ
±1.25 V, 50 Ω
Resolution 100 μV or 3 bits, the larger of the two
Accuracy Offset setting Value±2%
I/O
Standard Ports USB HOST (support USB-GPIB), USB DEVICE, LAN, Aux
Output (TrigOut/PassFail)
Printer
Compatibility
PictBridge