User Manual
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- MSO2000A/DS2000A Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 To Set the Vertical System
- Chapter 3 To Set the Horizontal System
- Chapter 4 To Set the Sample System
- Chapter 5 To Trigger the Oscilloscope
- Trigger Source
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Edge Trigger
- Pulse Trigger
- Runt Trigger
- Windows Trigger (Option)
- Nth Edge Trigger (Option)
- Slope Trigger
- Video Trigger (HDTV Option)
- Pattern Trigger
- Delay Trigger (Option)
- TimeOut Trigger (Option)
- Duration Trigger (Option)
- Setup/Hold Trigger
- RS232 Trigger
- I2C Trigger
- SPI Trigger
- USB Trigger (Option)
- CAN Trigger (Option)
- Trigger Output Connector
- Chapter 6 MATH and Measurements
- Chapter 7 Digital Channel
- Chapter 8 Protocol Decoding
- Chapter 9 Reference Waveform
- Chapter 10 Pass/Fail Test
- Chapter 11 Waveform Record
- Chapter 12 Display Control
- Chapter 13 Signal Source
- Chapter 14 Store and Recall
- Chapter 15 System Function Setting
- Chapter 16 Remote Control
- Chapter 17 Troubleshooting
- Chapter 18 Specifications
- Chapter 19 Appendix
- Index
RIGOL Chapter 14 Store and Recall
14-20 MSO2000A/DS2000A User’s Guide
Vertical Scale 1 U
Threshold A 0 V
Threshold B 0 V
Advanced Operation
Expression OFF
Expression CH1+CH2
Vertical Scale 2 V
Invert OFF
Logic Analyzer (LA)
[2]
Channel/Group D0
On/Off D7-D0: OFF; D15-D8: OFF
Waveform Size M
Reorder D0-D15
Threshold Type TTL
Digital Bus BUS1
BUS Status OFF
Channel Selection D7-D0
Endian Normal
Reference Clock None
Slope Rising Edge
Display Type Data
Format Hex
Jitter Rejection ON
Jitter Time 5.00 ns
Protocol Decoding (Decode 1, Decode 2)
Decoding Type Parallel
Bus Status OFF
Format Hex
Offset 0
Threshold 0
Parallel
Clock Channel CH1
Slope Rising Edge
Bus Bits 8