User Manual
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- MSO2000A/DS2000A Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 To Set the Vertical System
- Chapter 3 To Set the Horizontal System
- Chapter 4 To Set the Sample System
- Chapter 5 To Trigger the Oscilloscope
- Trigger Source
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Edge Trigger
- Pulse Trigger
- Runt Trigger
- Windows Trigger (Option)
- Nth Edge Trigger (Option)
- Slope Trigger
- Video Trigger (HDTV Option)
- Pattern Trigger
- Delay Trigger (Option)
- TimeOut Trigger (Option)
- Duration Trigger (Option)
- Setup/Hold Trigger
- RS232 Trigger
- I2C Trigger
- SPI Trigger
- USB Trigger (Option)
- CAN Trigger (Option)
- Trigger Output Connector
- Chapter 6 MATH and Measurements
- Chapter 7 Digital Channel
- Chapter 8 Protocol Decoding
- Chapter 9 Reference Waveform
- Chapter 10 Pass/Fail Test
- Chapter 11 Waveform Record
- Chapter 12 Display Control
- Chapter 13 Signal Source
- Chapter 14 Store and Recall
- Chapter 15 System Function Setting
- Chapter 16 Remote Control
- Chapter 17 Troubleshooting
- Chapter 18 Specifications
- Chapter 19 Appendix
- Index
Chapter 14 Store and Recall RIGOL
MSO2000A/DS2000A User’s Guide 14-17
Frequency 1.00 kHz
Amplitude 5.00 V
Offset 0.00 V
Start Phase 0.0°
Modulation OFF
Impedance HighZ
Cursor Setting (Cursor)
Mode OFF
Manual
Display Mode X-Y
Source CH1
Screen Region Main
Time Unit s
Vertical Unit Source Unit
Horizontal Positions of X Cursors
CursorA -4.000 μs
CursorB 4.000 μs
Vertical Positions of Y Cursors
CursorA 0.000 V
CursorB -4.000 V
Track
Source of CursorA CH1
Source of CursorB CH1
Horizontal Positions of X Cursors
CursorA -4.000 μs
CursorB 4.000 μs
Storage Setting (Storage)
Storage Type Setups (when no USB storage device is connected)
Picture (when a USB storage device is connected)
Utility Function Setting (Utility)
Sound
Sound OFF
Pass/Fail Test