User Manual
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- MSO2000A/DS2000A Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 To Set the Vertical System
- Chapter 3 To Set the Horizontal System
- Chapter 4 To Set the Sample System
- Chapter 5 To Trigger the Oscilloscope
- Trigger Source
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Edge Trigger
- Pulse Trigger
- Runt Trigger
- Windows Trigger (Option)
- Nth Edge Trigger (Option)
- Slope Trigger
- Video Trigger (HDTV Option)
- Pattern Trigger
- Delay Trigger (Option)
- TimeOut Trigger (Option)
- Duration Trigger (Option)
- Setup/Hold Trigger
- RS232 Trigger
- I2C Trigger
- SPI Trigger
- USB Trigger (Option)
- CAN Trigger (Option)
- Trigger Output Connector
- Chapter 6 MATH and Measurements
- Chapter 7 Digital Channel
- Chapter 8 Protocol Decoding
- Chapter 9 Reference Waveform
- Chapter 10 Pass/Fail Test
- Chapter 11 Waveform Record
- Chapter 12 Display Control
- Chapter 13 Signal Source
- Chapter 14 Store and Recall
- Chapter 15 System Function Setting
- Chapter 16 Remote Control
- Chapter 17 Troubleshooting
- Chapter 18 Specifications
- Chapter 19 Appendix
- Index
Chapter 14 Store and Recall RIGOL
MSO2000A/DS2000A User’s Guide 14-11
English Input Method
For example, create a file or folder with the name “Filename”.
1. Press Keyboard.
1) Use to select English input method “En” and uppercase input state “
a
A”.
2) Use to input the letter “F”. If the input is wrong, press Delete to delete
the character input.
3) Use
to select lowercase input state “
A
a”.
4) Use
to input the remaining letters “ilename”.
Figure 14-8 English Input Example
2. During the name input, you can press Name to select the “Name Input Area”
and use to move the cursor, then press Delete to delete the characters one
by one.
3. After finishing the input, press OK and the oscilloscope will create a folder or a
specified type of file with this name under the current directory.
Name Input Area Keyboard Upper-lower Case Switch Input Method Switch