User`s guide

RIGOL Chapter 2 Front Panel Operations
2-12 M300 User’s Guide
Channel Configuration
After creating a new scan list and configuring proper parameters (such as the scan
sweep and trigger mode), you need to add channels into the scan list and configure
the measurement, scaling, alarm and advanced parameters of the channels. The
M300 provides special channel configuration guide for you to easily finish the
channel configuration.
The flow diagram of the channel configuration guide is as shown in the figure below.
Figure 2-3 Flow Diagram of Configuration Guide
Note
[1]
: for multiplexer channels using the “SENSOR” function or the DIO channels and TOT
channels of the multifunction module, the configuration guide does not contain “Scaling
Configuration”.
Note
[2]
: for the multiplexer channels, if the DMM module is not inserted or it is inserted but is not
enabled, you can connect an external DMM for scan and measurement. At this point, the
configuration guide does not contain “Scaling Configuration” and “Alarm Configuration” and there
are some differences in “Measurement Configuration” and “Advanced Configuration”.
Press ConfigEditNew to enter the channel configuration guide. After finishing
all the configurations, press Done.
Measurement Configuration
Scaling Configuration
[1] [2]
Alarm Configuration
[2]
Advanced Configuration
Start
Done