User`s guide

RIGOL Chapter 2 Front Panel Operations
2-2 M300 User’s Guide
Scan Configuration
Press Config at the front panel to configure M300 to create a scan (create and edit
the scan list and configure the parameters of each channel). During the scan, each
time the DMM module is connected to one channel in the scan list and executes a
measurement according to the channel configuration.
Scan List
Create a scan list, add any channels of the multiplexer or the DIO or TOT channels of
the multifunction module to the scan list and configure the basic measurement,
scaling, alarm and advanced measurement parameters for each channel. The edited
scan list can be stored in internal or external memory and be recalled when required.
To Create a New List
The instrument enters the scan list configuration interface when you start the M300
or press Config. You can set the scan parameters (such as sweep count, tigger
mode) as well as create, edit, recall and save the scan list.
Figure 2-1 Scan List Configuration Interface
1 To Create Scan List
Press New to create a new scan list and enter the filename input interface. At
this point, you can input the desired list name by referring to “
To Input
Filename” and press OK. The scan list name can consist of Chinese characters,
English uppercase/lowercase letters and numbers and can not exceed 12 bytes