User`s guide

RIGOL Chapter 1 Quick Guide
1-16 M300 User’s Guide
Insert the Module into the Mainframe
Please turn the mainframe off and insert the modules following the instructions
below.
As shown in Figure 1-7, there is a golden circuit board edge both on the top and
bottom of the module. Aim the two edges with the sliding chutes (as pointed out by
the arrows in the figure below) into the main frame slot and push the module in until
you hear a sound. At this point, interface 2 is connected to the main frame.
Note: please refer to “Measurement Connections” to connect the external
terminal block and the signals to be measured and then insert it into the mainframe.
Figure 1-8 Insert the Module into the Mainframe
Note:
All the modules of the M300 do not support hot-plugging. Please turn the
mainframe off before inserting the modules into the mainframe.