User`s guide

Chapter 4 Remote Control RIGOL
M300 User’s Guide
4-7
To Control M300 through USB
1 Connect the devices
Connect M300 (USB Device) with your PC (USB Host) using USB cable.
2 Install the USB drive
As this instrument is a USB-TMC device, after you connect it to the PC and turn
both on, the PC will display the hardware update wizard dialog box. Please install
the “USB Test and Measurement Device (IVI)” driver following the directions of
the wizard. The detailed steps are the same as the instruction in “User-defined
Programming”.
3 Search device resource
Start up Ultra Sigma, the software starts searching the generator resources
currently connected to the PC automatically, or click
to search
manually. The status bar of Ultra Sigma at present is as shown in the figure
below:
4 View the resource
The resources that have been searched successfully are shown under the
“RIGOL Online Resource” catalog and the instrument model and the USB
interface information are also displayed, as shown in the figure below.
5 Communicate test
Right click the resource name “M300
(USB0::0x1AB1::0x0C80::M3001111333::INSTR)” and select “SCPI Panel
Control” to open the remote command control panel through which users can
send commands and read data, as shown in the figure below.