User`s guide

RIGOL Chapter 4 Remote Control

4-4 M300 User’s Guide

 Using RS232 Interface:

Convert the [RS-232/Alarms/Ext Trig] interface at the rear panel to two

9-pin interfaces using the Mixed Interface Convert Cable (accessory).

Wherein, one is a 9-pin male interface used as a standard RS232 interface.

Connect this interface with the computer using RS232 cable and set proper

parameters according to “To Set RS232 Parameters

”.

 Using LAN Interface:

Connect M300 to the LAN of the computer and set proper parameters

according to “To Set LAN Parameters”.

3 Programming

Then, you can select a familiar software developing tool (such as LabVIEW,

Matlab, Visual C++, etc.) for programming. For detailed information about SCPI

commands and programming method of M300, refer to M300 Programming

Guide.