User`s guide

Chapter 4 Remote Control RIGOL
M300 User’s Guide
4-1
Chapter 4 Remote Control
This chapter introduces the method to control M300 remotely. You can bulid
communication between M300 and computer via GPIB, USB, RS232or LAN to realize
remote control based on the SCPI (Standard Commands for Programmable
Instruments) commands. There are two remote control methods, including
user-defined programming and sending command using PC software.
Note: when the instrument is working in remote mode, Rmt is displayed in the status
bar in the user interface and the keys except Monitor,
and at the
front panel are locked. At this point, you can press to exit the remote mode.
Topics in this chapter:
 User-defined Programming
 To Use PC Software