User`s guide

Chapter 2 Front Panel Operations RIGOL
M300 User’s Guide
2-79
Separator
None
Power-on
Default
Power Key
OFF
Module Plug
No change
Brightness
8
Error Queue
Not cleared
Power-on Settings
Use the up/down direction keys to select Power-on and use the left/right direction
keys to select “Default” or “Last” (the configuration before the last power-off) as the
initial status at power-on. If “Default” is selected, the system will be restored to its
factory settings when starting up next time. The following settings always recall the
configuration before the last power-off and will not be affected by “Default”.
 Power Switch
 Language
 Module Plug
 I/O Configuration
Power-off Status
Use the up/down direction keys to select Power-off and use the left/right direction
keys to select “ON” or “OFF” (the default is “OFF”). When “ON” is selected, the
prompt message asking whether you want to restore all the settings to the status
before the last power-off will be displayed. Press OK.
Preset Settings
Use the up/down direction keys to select Preset and use the left/right direction keys
to select “ON” or “OFF” (the default is “OFF”). When “ON” is selected, the prompt
message asking whether you want to restore all the settings to the preset status will
be displayed. Press OK. The preset settings are as shown in the table below.
Table 2-6 Preset Settings
Parameter
Factory Setting
Scan Configuration
Scan List
No change
Reading Memory
Cleared
Max, Min, Average and SDEV
Cleared
Trigger Mode
No change
Scan Interval
No change