User`s guide

Chapter 2 Front Panel Operations RIGOL
M300 User’s Guide
2-75
Utility
Press Utility at the front panel to enter the utility interface in which you can set the
system parameters and I/O parameters, view the system information as well as
update the system.
Figure 2-38 Utility
1 System
Press System to set the system parameters such as the date, time and
language. For details, refer to “
System Setting”.
2 I/O
Press I/O to configure the remote interfaces such as RS232 and LAN. For
details, refer to “
I/O Configuration”.
3 Information
Press Info to view the instrument serial number, software version, etc.
4 Detect
Press Detect to execute self-test or view the type, model, serial number and
version of the module in each slot.
5 Update
Insert the USB storage device with the update file. After the instrument
recognizes the USB storage device, press this softkey, the instrument read the
update file and finish the update automatically. The update takes into effect
after restarting the instrument. Note: before updating the system, make sure
the instrument power source is stable and the instrument is in non-operation
state.