Specifications

RIGOL Chapter 2 Command System

2-60 M300 Programming Guide

*SAV

*RCL

Syntax *SAV {0|1|2|3|4|5}

*RCL {0|1|2|3|4|5}

Description The *SAV command stores the current measurement configuration to the specified

location and overwites any file previously stored in the current storage location (no error

is generated). The *RCL command recalls the measurement file stored in the specified

location and overwrites the current measurement configuration.

Explanation  The instrument has six storage locations in the non-volatile memory (refer to

Appendix C: Non-volatile Memory) for the measurement configuration. You can store

the current measurement configuration into the measurement configuration file in

any of the six storage locations (named location 0, 1, 2, 3, 4, and 5. The default file

names corresponding to the locations are 0_STATE0, 1_STATE1, 2_STATE2,

3_STATE3, 4_STATE4 and 5_STATE5).

 The extension of the measurement configuration file is “.mfg”.

 The measurement configuration stores the scan list settings (include the trigger

count, trigger mode, interval for auto trigger mode and trigger edge type for external

trigger) and the channel configurations (include the measurement configuration,

scalling configuration, alarm configuration and advanced configuration).

 When shipped from the factory, all the measurement configuration files in the six

storage locations are empty.

 If the measurement configuration file of the specified location dose not exist

(Sending the

SYSTem:SECurity[:IMMediate] command will delete all the files of the

memory) , you can send the

*SAV command to create the measurement

configuration file of the specified location.

 A Factory Reset (the

*RST command) does not affect the measurement configuration

file stored in the specified location. Sending the

SYSTem:SECurity[:IMMediate]

command will delete all the measurement configuration files of the memory.

Commands

MEMory:STATe:DELete

MEMory:STATe:NAME

MEMory:STATe:VALid?