Specifications

RIGOL Chapter 2 Command System
2-46 M300 Programming Guide
DIAGnostic:RELay:CYCLes:CLEar
Syntax
DIAGnostic:RELay:CYCLes:CLEar (@<ch_list>)
Description
Reset the cycle count of the specified channel relays.
Parameters
Name
Type
Range
Default
<ch_list>
Channel
List
One or more channels (for the multiplexer,
actuator and matrix switch channels), the rules
are as follows:
(@101): channel 01 on the module in Slot1;
(@101:103): channel 01 through 03 on the
module in Slot1;
(@101:103,301): channel 01 through 03 on the
module in Slot1 and channel 01 on the module in
Slot3.
None
Explanation  The command reset the cycle counts of the channel relays and group relays of
each module (except the DMM module and Multifunction module). For the location
of each module relay, please refer to
Appendix E: Module Schematic Diagram.
 To reset the cycle count of the relays on the DMM module, use the
DIAGnostic:DMM:CYCLes:CLEar command.
Example DIAG:REL:CYCL:CLE (@101:108)
DIAG:REL:CYCL? (@101:108)
The query returns +0,+0,+0,+0,+0,+0,+0,+0.
Related
commands
DIAGnostic:DMM:CYCLes:CLEar
DIAGnostic:RELay:CYCLes?