Specifications

RIGOL Chapter 2 Command System
2-38 M300 Programming Guide
100PLC
0.035ppm× <range>
200PLC
0.03ppm× <range> (MIN)
 The *RST command will clear the scan list and set all the measurement parameters to
their factory settings. The Instrument Preset (the
SYSTem:PRESet command) will not
clear the scan list; however, this command will clear the data in the reading memory.
 If the input signal is greater than can be measured on the selected range (manual
ranging), the instrument gives an overload indication: "OVERLOAD" from the front
panel or "±9.9E+37" from the remote interface.
 <scan_list> overwrites the current scan list.
Example CONF:VOLT:DC 20,DEF,(@101)
Related
commands
CONFigure?
INITiate
READ?