Specifications

RIGOL Chapter 2 Command System

2-28 M300 Programming Guide

100PLC

0.035ppm× <range>

200PLC

0.03ppm× <range> (MIN)

 If the input signal is greater than can be measured on the selected range, the

instrument gives an overload indication: "OVERLOAD" from the front panel or

"±9.9E+37" from the remote interface.

 The

*RST command will clear the scan list and set all the measurement parameters to

their factory settings. The Instrument Preset (the

SYSTem:PRESet command) will not

clear the scan list; however, this command will clear the data in the reading memory.

 <scan_list> overwrites the current scan list.

Example CONF:CURR:DC AUTO,DEF,(@121)

commands

CONFigure?

INITiate

READ?