Specifications

RIGOL Chapter 4 Programming Demos
4-50 M300 Programming Guide
6) You can select a channel from the scan list (Scanlist combox) and remove it from the scan list by
clicking the Remove channel from scanlist button.
For example, the current scan list was configured as step 5). Select channel 101 from the Scanlist
ComBox, and click the Remove channel from scanlist button to remove channel 101 from the
scan list. Query the current scan list configuration by clicking the Query Scanlist button. The
running results are as follows.
7) Click the InitScan button to place the instrument in the "wait-for-trigger" state.
8) Click the Abort button to abort the scan in progress.
9) Click the Query Scanlist button to query the configuration of the scan list.
10) Click the Clear Scanlist button to remove all the channels from the scan list.
11) Click the Monitor ON button to enable the single-channel monitor mode.
12) Click the Monitor OFF button to disable the monitor mode.
13) Click the System Error button to query a system error. Click the read button to read and clear
the error.