Specifications

Chapter 2 Command System RIGOL
M300 Programming Guide 2-221
SYSTem:UTIlity:CONFigure:POWEron
Syntax SYSTem:UTIlity:CONFigure:POWEron LAST|DEF
SYSTem:UTIlity:CONFigure:POWEron?
Description
Set or query thepower-on value of the instrument.
Parameters
Name
Type
Range
Default
{DEFault|LAST}
Discrete
DEFault|LAST
DEFault
Explanation  LAST: the instrument uses the system configuration before the last power-off at
power-on.
 DEFault: the instrument uses the factory settings (refer to
Appendix A: Factory
settings) at power-on, except those parameters (as shown below) that will not be
affected by reset.
[1] Power Switch
[2] Language
[3] Module Plug
[4] I/O Configuration
 The power-on value of the instrument is set to “DEFault” after a Factory Reset (send
the *RST command).
Return
Format
The query returns DEFAULT or LAST.
Example
SYST:UTI:CONF:POWE LAST
SYST:UTI:CONF:POWE?
The query returns LAST.
Related
commands
SYSTem Command Subsystem
*RST
SYSTem:UTIlity:DISPlay:BRIGht
Syntax SYSTem:UTIlity:DISPlay:BRIGht <value>
SYSTem:UTIlity:DISPlay:BRIGht?
Description
Set or query the brightness of the screen.
Parameters
Name
Type
Range
Default
<value>
Integer
0 to 15
8
Explanation
The brightness of the screen is set to 8 after a Factory Reset (send the *RST command).
Return
Format
The query returns an integer from 0 to 15, for example, 5.
Example
SYST:UTI:DISP:BRIG 10
SYST:UTI:DISP:BRIG?
The query returns 10.
Related
command
SYSTem Command Subsystem