Specifications
Chapter 2 Command System RIGOL
M300 Programming Guide 2-207
SYSTem:COMMunicate:LAN:TELNet:PROMpt
SYSTem:COMMunicate:LAN:TELNet:WMESsage
Syntax SYSTem:COMMunicate:LAN:TELNet:PROMpt "<string>"
SYSTem:COMMunicate:LAN:TELNet:PROMpt?
SYSTem:COMMunicate:LAN:TELNet:WMESsage "<string>"
SYSTem:COMMunicate:LAN:TELNet:WMESsage?
Description Set the command prompt and welcome message when a Telnet session is used to
communicate with the instrument.
Parameters
Name
Type
Range
Default
<string>
ASCII
string
Up to 15 characters (prompt);
Up to 63 characters (welcome message).
None
Explanation By now, the function of using Telnet session to communicate with the instrument is not
supported by M300, but you can still use these commands.
The command prompt and welcome message are stored in the non-volatile memory
(refer to
Appendix C: Non-volatile Memory) and they do not change when the power
has been off, after a Factory Reset (send the
*RST command) or after an Instrument
Preset (send the SYSTem:PRESet command).
Return
Format
The queries return strings enclosed in double quotation marks.
Example
SYST:COMM:LAN:TELN:WMES “Welcome to Rigol Technologies' M300 Switch/Measure
Unit”
SYST:COMM:LAN:TELN:WMES?
Typical Response:“Welcome to Rigol Technologies' M300 Switch/Measure Unit”
SYST:COMM:LAN:TELN:PROM "Command"
SYST:COMM:LAN:TELN:PROM?
The query returns "Command".
Related
command
SYSTem Command Subsystem