Specifications

Chapter 2 Command System RIGOL
M300 Programming Guide 2-3
CALCulate Command Subsystem
M300 supports the scaling function and alarm function. You can configure the scaling parameters and alarm
parameters for the channels in scan list. The DMM module stores the measurement readings and performs
statistical calculations during the scan process. You can query the statistical calculation results at any time
(even during a scan). The CALCulate commands are mainly used to set the alarm parameters and scaling
parameters as well as query the statistical calculation results.
 CALCulate:AVERage:AVERage?
 CALCulate:AVERage:MAXimum?
 CALCulate:AVERage:MINimum?
 CALCulate:AVERage:PTPeak?
 CALCulate:AVERage:SDEV?
 CALCulate:AVERage:CLEar
 CALCulate:AVERage:COUNt?
 CALCulate:AVERage:MAXimum:TIME?
 CALCulate:AVERage:MINimum:TIME?
 CALCulate:COMPare:DATA
 CALCulate:COMPare:MASK
 CALCulate:COMPare:STATe
 CALCulate:COMPare:TYPE
 CALCulate:LIMit:LOWer
 CALCulate:LIMit:UPPer
 CALCulate:LIMit:LOWer:STATe
 CALCulate:LIMit:UPPer:STATe
 CALCulate:SCALe:SQUare
 CALCulate:SCALe:GAIN
 CALCulate:SCALe:OFFSet
 CALCulate:SCALe:CONStant
 CALCulate:SCALe:OFFSet:NULL
 CALCulate:SCALe:STATe
 CALCulate:SCALe:UNIT