Specifications
Chapter 2 Command System RIGOL
M300 Programming Guide 2-173
[SENSe:]TOTalize:STOP[:IMMediate]
Syntax
[SENSe:]TOTalize:STOP[:IMMediate] [(@<ch_list>)]
Description
Enable the specified totalizer channels to stop counting immediately.
Parameters
Name
Type
Range
Default
<ch_list>
Channel
List
One or more channels (only for the TOT
channels), the rules are as follows:
(@105): channel 05 on the module in Slot1;
(@105:108): channel 05 through 08 on the
module in Slot1;
(@105:108,305): channel 05 through 08 on
the module in Slot1 and channel 05 on the
module in Slot3.
If the parameter
is omitted, this
command will be
applied to the
whole scan list.
Explanation The totalizer channels are numbered as "S05" to "S08"; wherein, S is the number of
the slot.
Example
TOT:STOP:IMM (@105)
Related
commands
SENSe Command Subsystem
[SENSe:]TOTalize:STARt[:IMMediate]
[SENSe:]TOTalize:DATA?
[SENSe:]TOTalize:STOP:DEFault
Syntax
[SENSe:]TOTalize:STOP:DEFault [(@<ch_list>)]
Description Enable the specified totalizer channels to stop counting at power-on when the specified
totalizer channels are already enabled to start counting at power-on by sending the
[SENSe:]TOTalize:STARt:DEFault command.
Parameters
Name
Type
Range
Default
<ch_list>
Channel
List
One or more channels (only for the TOT
channels), the rules are as follows:
(@105): channel 05 on the module in Slot1;
(@105:108): channel 05 through 08 on the
module in Slot1;
(@105:108,305): channel 05 through 08 on
the module in Slot1 and channel 05 on the
module in Slot3.
If the parameter
is omitted, this
command will be
applied to the
whole scan list.
Explanation The totalizer channels are numbered as "S05" to "S08"; wherein, S is the number of
the slot.
Example
TOT:STOP:IMM (@105)
Related
commands
SENSe Command Subsystem
[SENSe:]TOTalize:STARt:DEFault
[SENSe:]TOTalize:DATA?