Specifications

Chapter 2 Command System RIGOL
M300 Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter and using instruction of each M300 command in
A-Z order.
Main topics of this chapter:
 ABORt
 CALCulate Command Subsystem
 CONFigure Command Subsystem
 DATA Command Subsystem
 DIAGnostic Command Subsystem
 DISPlay Command Subsystem
 FETCh?
 FORMat Command Subsystem
 IEEE-488.2 Common Commands
 INITiate
 INPut:IMPedance:AUTO
 INSTrument Command Subsystem
 LXI Command Subsystem
 MEASure Command Subsystem
 MEMory Command Subsystem
 MMEMory Command Subsystem
 OUTPut Command Subsystem
 R?
 READ?
 ROUTe Command Subsystem
 SENSe Command Subsystem
 SOURce Command Subsystem
 STATus Command Subsystem
 SYSTem Command Subsystem
 TRIGger Command Subsystem
 UNIT Command Subsystem
Note*: M300 provides a set of standard values for setting some parameters, such as the range, resolution and
integration time. When the parameter value sent is not one of the standard values, M300 will set the parameter
according to the “Using the greater value principle*” or “Using the smaller value principle*” (no error will be
generated).
Using the greater value principle*: if the specified value is different from the standard value of this parameter, the
first standard value of this parameter that is greater than the specified value will be selected for this parameter.
Using the smaller value principle*: if the specified value is different from the standard value of this parameter, the
first standard value of this parameter that is smaller than the specified value will be selected for this parameter.