Specifications

Chapter 2 Command System RIGOL
M300 Programming Guide 2-117
 [SENSe:]VOLTage:AC:BANDwidth
 [SENSe:]VOLTage:AC:RESolution
 [SENSe:]VOLTage[:DC]:APERture
 [SENSe:]VOLTage[:DC]:NPLC
 [SENSe:]VOLTage[:DC]:RESolution
 [SENSe:]ZERO:AUTO
Note*:
 You cannot set any function-specific measurement parameters unless the channel is already configured for that
function. For example, you cannot set the AC filter parameters unless that channel is already configured for the
ACV, ACI, frequency or period measurements.
 If you omit <ch_list> in the SENSe commands, the commands will be applied to the currently defined scan list.
But sending this command will generate an error if there is measureemtn function in the scan list which does not
match the specified measurement parameter.