Specifications

Chapter 1 Programming Overview RIGOL
M300 Programming Guide 1-3
cable. Press Utility  I/O  RS232, select Print and then select "No" to deisable the
measurement data print function of the RS232 interface.
 Set interface parameters (baud rate, flow control and etc) which match the PC or terminal
equipment.
(4) Use the GPIB interface:
 Connect the instrument with your PC (GPIB card is installed) using a GPIB cable.
 Press Utility  I/O  GPIB to set the GPIB address of the instrument.
3 Check whether the connection is successful
Run the Ultra Sigma, search for resource, right-click the resource name and select “SCPI Panel Control”
in the pop-up menu. Enter the correct command in the pop-up SCPI control panel and click Send
Command, Read Response or Send&Read to check whether the connection is successful, as
shown in the figure below (take the USB interface as an example).