Specifications

RIGOL
10 M300 Selection Guide
DMM Module
The DMM module (MC3065) is used to measure the signals under test and has 6½ digit reading
resolution. The measurement functions include DCV, ACV, DCI, ACI, 2-wire resistance, 4-wire resistance,
frequency, period, temperature and any sensor. After connecting the DMM module, make sure that the
signal under test connected to the analog bus is no greater than 300Vdc or 300Vrms.
The DMM module is as shown in the figure below. The DMM module does not have interface 1 (namely
the 78Pin interface; for the interface definition, refer to Figure 1).
Figure 7 MC3065