Specifications

RIGOL
8 M300 Selection Guide
Figure 4 Connect the Terminal Block and Module
4. Close the upper cover of the terminal block.
Figure 5 Close the Upper Cover of the Terminal Block
5. Insert the module connected with the terminal block into the slot of the mainframe. As shown in
Figure 1, there is a golden circuit board edge both on the top and bottom of the module. Aim the two
edges with the sliding chutes in the main frame slot and push the module in until you hear a sound.
At this point, interface 2 (for the interface definition, refer to Figure 1) is connected to the main
frame.
Figure 6 Insert the Module Connected with the Terminal Block into the Main Frame Slot
Note:
All the modules of M300 do not support hot-plugging. Therefore, please turn the main frame off
before inserting the modules into the main frame.