User manual

User’s Guide for DSA800 Series
Chapter 2 Front Panel Operation RIGOL
2-39
 Fail Stop: select whether to perform the next sweep if the test fails.
 Beeper: turn on or off the beeper. When the beeper is on, it beeps when
the test fails.
3. Restart
Re-execute the active or suspended test.
4. Pause
Suspend the test after the current test is finished. At this point, the
measurement data stops updating, but the sweep continues. is displayed
in the test result display window.
5. Resume
Resume the suspended test and the test data begins updating again. is
displayed in the test result display window.
6. Meas Mode
Set the measurement mode to single or continuous. In single mode, the
analyzer stops after a specified number of tests. After this, every time when
Single is pressed, the system executes specified number of tests and updates
the test data. In continuous mode, the analyzer tests continuously.
7. Single
In single mode, the analyzer stops after a specified number of tests. After this,
every time when Single is pressed, the system executes specified number of
tests and updates the test data.