User manual

User’s Guide for DSA800 Series
Chapter 2 Front Panel Operation RIGOL
2-31
Press “Single”
Measuring status?
Single sweep status? Single sweep status?
Enter single sweep mode
and wait for trigger
condition
Enter single sweep/
measure mode and wait
for trigger condition
Sweep again and wait
for trigger condition
Wait for trigger condition
and make single
measurement again
N
N
N
Y
Y
Y
Figure 2-10 Process of Single Sweep
Numbers
Set the number of sweeps for a single sweep. In single mode, the system executes
specified number of sweeps and the number shown on the icon in the status bar at
the left of the screen varies with the process of the sweep.
Table 2-16 Numbers
Parameter
Explanation
Default
1
Range
1 to 9999
Unit
N/A
Knob Step
1
Direction Key Step
1