User manual

User’s Guide for DSA800 Series

Chapter 2 Front Panel Operation RIGOL

2-21

Table 2-10 Edit menus of Amplitude correction

Explanation

Point

Create or edit the data point of a correction factor.

Range: 1 to 200

Frequency

Set the frequency of the specified point in the correction

facor.

Amplitude

Set the amplitude correction of the specified point in the

correction facotr.

Range: -120 dB to 100 dB

Del Point

Delete the specified point data in the correction factor:

frequency and amplitude correction.

4. Freq Interp

Set the interpolation type of the points between two points in the correction

table during amplitude correction.

 In Lin mode, the frequency and amplitude separately use a Lin and Log

unit to perform interpolation.

 In Log mode, both of the parameters use a Log unit.

5. Delete

Clear the frequency and amplitude correction data of the selected correction

factor.

6. Corr Table

Turn on the correction table to view the correction data edited. At this

moment, the screen is divided into two parts with the upper showing the

measurement curve and the lower showing the points edited, frequency, and

amplitude.

7. Corr View

 All: view the data of all the correction factors.

 Sel: view the data of the selected correction factor.