User manual

Chapter 4 Troubleshooting&Message RIGOL
User’s Guide for DSA800 Series
4-15
Device Specific Error
Number
Error Description
-300
Device-specific error.
A generic device-dependent error indicates that the device cannot detect
more specific errors. This code indicates that only a Device-Dependent
Error defined in IEEE 488.2, 11.5.1.1.6 has occurred. Please report the
error to your RIGOL sales or technical support team.
-310
System error.
Indicate that some error, termed “system error” by the device, has
occurred. Please report the error to your RIGOL sales or technical
support team.
-311
Memory error.
Indicate that local C disc is not formatted or an error occurred during
self-test. If restarting the device is still of no effect, please report the
error to your RIGOL sales or technical support team.
-313
Calibration memory lost.
Indicate that the data before delivery or last valid calibration data has
been lost. Please report the error to your RIGOL sales or technical
support team.
-314
Save/recall memory lost.
Indicate that the nonvolatile data saved by the *SAV? command has been
lost.
-315
Configuration memory lost.
Indicate that nonvolatile configuration data saved by the device has been
lost.
-321
Out of memory.
An internal operation needed more memory than that was available.
Please report the error to your RIGOL sales or technical support team.
-330
Self-test failed.
The self-test failed. For more information, please refer to the result of the
Self-test.
-340
Calibration failed.
The calibration failed. Please report the error to your RIGOL sales or
technical support team.