User manual

Chapter 4 Troubleshooting&Message RIGOL
User’s Guide for DSA800 Series
4-3
4. Wrong measurement results or poor precision:
To calculate the system errors and check the measurement results and precision,
refer to the introductions in “Specifications”. To reach these specifications,
please:
(1) Check whether all the external devices are successfully connected and are
working normally.
(2) Have some knowledge of the signal under measurement and set
appropriate instrument parameters.
(3) Make measurements under proper conditions, for example, warm-up the
instrument appropriately and operate under the specified environment
temperature.
(4) Calibrate the instrument regularly to reduce or avoid errors that might
occur over time.
— If you need a specific calibration after the stated calibration period,
contact RIGOL or get paid service from authorized measurement
agencies.
— The analyzer provides self-calibration function. If required, press
System  Calibrate  Self-Cal, and the instrument will perform
self-calibration automatically once the operating temperature changes.
— Press System  Calibrate  Cal Now to make a self-calibration
immediately.
5. Pop-up Message:
The instrument may display prompt messages, error messages or state
messages according to the current working status. These messages are
displayed to help you to use the instrument correctly and are not instrument
failures. For information of the pop-up messages, please refer to
“Messages”.