User manual

Chapter 3 Remote Control RIGOL
User’s Guide for DSA800 Series
3-11
6) Load LXI webpage
The analyzer conforms to LXI-C standards. You can load LXI webpage
conveniently through Ultra Sigma (right-click the resource name and
select “LXI-Web”). On the webpage, some important information about
the analyzer such as the model, manufacturer, serial number, description,
MAC address and IP address is shown as shown in the figure below.
Figure 3-7 LXI Webpage
3. Remote Control via GPIB
1) Connect the devices
Connect the analyzer to the PC (configured with GPIB card) using
RIGOL USB-GPIB interface converter (option).
2) Install the device driver of the GPIB card
Install the driver of the GPIB card connected to the PC.
3) Set the GPIB address
Set the GPIB address of the analyzer according to the description in
“GPIB” of “I/O Settings”.
4) Search device resource
Start-up Ultra Sigma and click to open the panel as
shown in the figure below. Then, click “Search” and the software starts
searching the GPIB device resources connected to PC automatically.
When a GPIB resource is found, the device source descriptor of it will be