User manual

RIGOL Chapter 2 Front Panel Operation
User’s Guide for DSA800 Series
2-106
2. LAN
Set or reset the LAN parameters.
Figure 2-29 LAN parameter setting
The following items can be set through the front panel or remote interface.
 Reset:
Turn on DHCP and Auto-IP, turn Manual-IP off, and then clear the
network password set.
 Config:
After the LAN interface configuration is finished, press Config  OK to
apply the configuration.
 DHCP:
One of the setting methods of IP address. When DHCP is enabled, the
DHCP server assigns network parameters (such as the IP address, subnet
mask and gateway) to the analyzer on the basis of the current network
configuration.
 Auto-IP:
One of the setting methods of IP address. When auto IP is enabled, the