User manual

RIGOL Chapter 3 Remote Control
User’s Guide for DSA800 Series
3-8
5) Communication test
Right click the resource name such as
DSA815 (USB0::0x1AB1::0x04B0::DSA8A134400002::INSTR)
and select SCPI Panel Control to open the remote control panel (as
shown in the figure below) from which you can write commands and read
data.
Figure 3-3 Write and Read Commands via USB
2. Remote Control via LAN
1) Connect the devices
Connect the analyzer to your LAN.
2) Configure LAN parameters
Select LAN interface according to the description in “LAN” of “I/O
Settings”.
3) Search device resourse
Start-up Ultra Sigma and click . Then, click
in the pop-up window and the software starts searching the analyzer
resources connected to LAN. When a LAN resource is found, the name of
it will be displayed in the resource box on the right side of the panel.
Select the desired resourse and click to add the resource.