User manual

Chapter 2 Command System RIGOL
DSA700 Programming Guide 2-1
Chapter 2 Command System
In this chapter, the DSA700 series spectrum analyzer command subsystems are introduced in alphabetical
order (from A to Z).
Main topics of this chapter:
 :ABORt
 :CALCulate Subsystem
 :CALibration Subsystem
 :CONFigure Subsystem
 :COUPle Subsystem
 :DISPlay Subsystem
 :FETCh Subsystem
 :FORMat Subsystem
 :HCOPy Subsystem
 IEEE 488.2 Common Commands
 :INITiate Subsystem
 :INPut Subsystem
 :MMEMory Subsystem
 :READ Subsystem
 [:SENSe] Subsystem
 :STATus Subsystem
 :SYSTem Subsystem
 :TRACe Subsystem
 :TRIGger Subsystem
 :UNIT Subsystem
Explanation:
1. In this command set, commands relating to Quasi-peak detector, EMI filter, advanced measurement,
Sig Capture and TX1000 are only applicable to DSA700 installed with the corresponding options. For
the details, refer to the explanation in each command subsystem.
2. In this command set, unless otherwise noted, the query returns "N/A" (quotation marks excluded) if
the corresponding option is not installed and returns "ERR" (quotation marks excluded) if the
corresponding function is not enabled or the type does not match.
3. In this manual, the parameter ranges of the commands are based on DSA710.