Instructions

Chapter 20 Remote Control RIGOL
MSO7000/DS7000 User's Guide 20-1
Chapter 20 Remote Control
The oscilloscope can be remotely controlled in the following two methods:
User-defined programming
You can program and control the oscilloscope by using the SCPI (Standard
Commands for Programmable Instruments) commands. For details about the
relevant commands and programming, refer to MSO7000/DS7000 Series
Programming Guide .
PC software
You can use the PC software to send commands to control the oscilloscope remotely.
RIGOL Ultra Sigma is recommended. You can download the software from RIGOL
official website (www.rigol.com).
Operation Procedures:
(1) Set up communication between the instrument and PC.
(2) Run Ultra Sigma and search for the instrument resource.
(3) Open the remote command control panel to send commands.
The oscilloscope can communicate with the PC via the following interfaces:
 Remote Control via USB
 Remote Control via LAN
 Remote Control via GPIB
This chapter will illustrate how to use RIGOL's Ultra Sigma software to remotely
control the oscilloscope via various interfaces.
CAUTION
Before setting up communication, please turn off the instrument to avoid
causing damage to the communication interfaces.