Instructions

Chapter 11 Protocol Decoding RIGOL

MSO7000/DS7000 User's Guide 11-5

 Set the endian

Press Endian continuously to select "Normal" or "Invert" as the endian of

the bus.

 Polarity

Press Polarity continuously to select Positive or Negative as the

polarity for data decoding.

4． Display-related setting

Press Display to enter the display setting menu.

 Set the display format

Press Format, rotate the multifunction knob to select the display

format of the bus data. Then, press down the knob to select it. You can also

press Format continuously or enable the touch screen to select it. The

available display formats of the bus data are "Hex", "Dec", "Bin", and

"ASCII".

 Adjust the vertical position of the bus

Press Position, and then rotate the multifunction knob to adjust the

vertical display position of the bus. You can also rotate Wave Vertical

POSITION to adjust the vertical display position of the bus.

 Set the label display

Press Label to enable or disable the label display of the Parallel decoding

bus. When enabled, the bus label "Parallel" will be displayed at the

upper-left side of the bus (when the bus display is enabled).

 Event table

Press Event Table to enter the event table setting menu. The event table

displays the detailed decoding information in time order in the form of a

table, so as to better observe the long decoded data. The decoding

information includes the decoded data, the corresponding line number, and

time information.

 Open or close the event table: Press Event Table continuously to

enable or disable the event table. When you enable the event table,

Channel Logic Level

Channel Signal Amplitude

Threshold Level