Instructions

Chapter 6 Operations and Measurements RIGOL
MSO7000/DS7000 User's Guide 6-3
to select the channel. You can also press SourceA and SourceB continuously
or enable the touch screen to select the channel. The available channels for
SourceA and SourceB are CH1, CH2, CH3, and CH4.
Note: Only the channels that have been enabled currently can be selected.
 Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "Parameter Setting Method". You can
also directly rotate Wave Vertical POSITION or enable the touch screen
to adjust the vertical offset.
 Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "Parameter Setting Method". You can also
directly rotate Wave Vertical SCALE or enable the touch screen to adjust
the vertical scale.
 Press More  AutoScale to adjust the vertical scale and the offset of the
operation results to the optimal value according to the current configuration, so
as to better to observe.
 Press More  Invert to enable or disable the inverted display function of the
waveform.
 Press More  Expand to expand or compress the math operation waveform
around the "Center" or "GND".
 Press More  Label to set the label for math operation results. For details,
refer to descriptions in "Math Operation Label".
Subtraction
Subtracts the waveform voltage values of signal source B from that of source A point
by point and displays the results.
Press Math  Math1  Operator to select "A-B":
 Press Operation continuously to enable or disable the subtraction operation
function.
 Press SourceA and SourceB respectively, and rotate the multifunction knob
to select the channel for SourceA and Source B. Then press down the knob
to select the channel. You can also press SourceA and SourceB continuously
or enable the touch screen to select the channel. The available channels for
SourceA and SourceB are CH1, CH2, CH3, and CH4.
Note: Only the channels that have been enabled currently can be selected.
 Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "Parameter Setting Method". You can
also directly rotate Wave Vertical POSITION or enable the touch screen
to adjust the vertical offset.
Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "Parameter Setting Method". You can also