User manual

RIGOL
MSO7000/DS7000 Quick Guide 11
English
Figure 6 To Connect the Passive Probe
After you connect the passive probe, check the probe function and probe
compensation adjustment before making measurements. For detailed
procedures, refer to "Function Inspection" in this manual and the "Probe
Compensation" section introduced in
MSO7000/DS7000 User's Guide .
Connect the active probe:
Take RP7080 (use the active differential probe head) as an example.
1. Connect the probe head to the preamp of the active probe, as shown in
Figure 7.
Figure 7 To Connect the Probe Head to the Preamp of the Active Probe
2. Connect the other end of the preamp to an analog channel input terminal
of the oscilloscope on the front panel, as shown in Figure 8. Note that you
should push the probe to the end to ensure that it is tightly connected.