User manual

RIGOL
10 MSO7000/DS7000 Quick Guide
English
Turn-on Checkout
When the oscilloscope is connected to power, press the Power key
at the
lower-left corner of the front panel to start the oscilloscope. (You can also press
Utility  System  Power status, and select "Switch On". After the
instrument is connected to power source, it will start directly. You can also
enable the touch screen to perform the above menu operation.) During the
start-up process, the oscilloscope performs a series of self-tests. After the
self-test, the welcome screen is displayed.
To Set the System Language
MSO7000/DS7000 series oscilloscope supports multiple system languages. You
can press Utility  Language to set the system language. You can also refer
to descriptions in "To Use the Built-in Help System" to open the "Help"
menu, and then press Language to set the system language. You can also
enable the touch screen to perform the above menu operation.
To Connect the Probe
RIGOL provides the passive probe, the active probe, and the logic probe for
MSO7000/DS7000 series. For specific probe models, please refer to
MSO7000/DS7000 Series Datasheet . For detailed technical information of the
probes, please refer to the specified Probe User’s Guide.
Connect the passive probe:
1. Connect the BNC terminal of the probe to an analog channel input
terminal of the oscilloscope on the front panel, as shown in Figure 6.
2. Connect the ground alligator clip or spring of the probe to the circuit
ground terminal, and then connect the probe tip to the circuit point to be
tested.