User Manual

RIGOL 10 Waveform Record
DS4000 User’s Guide
10-12
Analysis Based on Trace
Press Analyze and select “Trace”. Then, set the templet used in analysis based on
trace through the method below.
1. Trace
Press Trace to select the creation method of analysis templet.
 Current Frame: select the current frame as the analysis templet.
 Average: select the average of all the frames of this analysis as the analysis
templet.
2. Setup Templet
Press Setup Templet to configure the templet immediately. After the analysis
starts, the oscilloscope compares each frame with the templet to compute the
difference value and determines whether error frame exists by comparing the
difference value with the threshold currently set.