User manual

RIGOL Chapter 1 Calibration Notices

DS4000 Calibration Guide

1-2

Project Mode

1. Start the oscilloscope.

2. Press MENU in the TRIGGER control area at the lower-right corner of the front panel and then

set the trigger Type to “Edge”.

3. Press F7, F6, F7 and Utility (F7 and F6 are defined as shown in Figure 3) successively to enter

the project mode and select the second-page menu (Figure 4). (

Repeating step 2 and 3 can return

back to the normal mode).

Note: by default, the oscilloscope enters the normal mode after restart.

Figure 3

Figure 4